Check out the impressive features of this CSA-600 series fume extractor system for, among others and varied applications, laser marking, laser engraving, and laser cutting.
CSA-600 – Fume Extractor, Heavy Duty Dust & Odor Removal
Description
- The CSA is the workhorse fume extractor of the laser industry; designed to operate in a heavy duty environment. A large pre-filter bag that is easily accessed to change via a convenient side panel eliminates much of the debris that might otherwise clog the more expensive HEPA filters. A huge chemical bed of 66Lb. (30kg) provides significant odor and VOC protection for much longer than the light duty units again providing a solution that can withstand a heavy workload. Chemical compounds can be customized based on specific applications
- With large collection bag, HEPA Filter & Deepbed Odor filters
- LaserBlue Gel seal guarantees NO BYPASS
- Dual hi-speed turbine for high suction, pressure & airflow
- Whisper quiet operation is office friendly
- Universal design allows for 2.5", 3", 4" inlet along with discharge
Additional details:
Our CSA626 filter system is designed to remove both particulate matter and gas phase contaminants.
The equipment is designed with up to 4 stages of filtration each targeted for removal of specific size particles and gases.
There are a series of filters in the system to ensure that all particulate matter/ dust is removed efficiently.
The unit contains Merv 13 Bag filters, Deep Pleated high capacity safety filters and a MERV 17 99.97 % HEPA filter.
The HEPA filter is the last particulate filter in the sequence and it is designed to remove 99.97% of all particulate matter that is 0.3 microns and larger.
This is the same type of filter that is used in hospital operating rooms. Please note as the filters begin to get dirty they also become more efficient making the system more efficient as time goes on. This occurs as it gets more and more difficult for the dust to pass through the filter due to the passages becoming smaller as they become filled with debris.
F128 – Merv 13 Bag Filter
F074 – Merv 17 HEPA filter
F073 - Deep Pleated high capacity safety filter
The gas phase filter is quite large and 15” deep in direction of airflow. We have 26 different types of chemical media that can be incorporated into the chemical filter to address and deal with specific contaminants if required. Depending on the type of media the modules could weigh as much as 70 lbs. Our standard and most typical module contains a virgin bituminous coal extruded 3-4 mm carbon pellet. This carbon is ideal at removing many VOC’s and has a holding capacity as high as 25 % by weight. Initially the removal efficiency will be 100% for most VOC’s. Over time the mass transfer zone will travel through the chemical filter as it gets consumed. The chemical filter is seated inside a gel seal material to guarantee zero by-pass of the chemical filter. This is the same material that is used in Pharmaceutical and Hospital environment clean rooms. All gases therefore must pass through the chemical filter
AG111 – 15” deep bed gas phase chemical filter
LaserBlue Gel seal guarantees NO BYPASS
Unlike other systems that have a sprinkling of carbon our gas phase chemical filter is quite large and requires the use of high pressure blowers to overcome the resistance created by the deep bed chemical filter. Our blowers are capable of generating 90” water column of pressure. With this type of blower as the filters begin to get dirty and plugged we can still effectively overcome this increase in pressure allowing us to continue to evacuate the laser chamber. The system is equipped to advise you when the filters need to be changed.
Contact Us
- Toll Free: 1-888-395-0330 or 1-800-626-0664 (North America- Continental USA and Canada)
- Fax: 1 (419) 710-9876
- Outside of North America: 1 (514) 421-0658
You may also fax to us your information request: eFax: 1 (419) 710-9876 - Contact Us Form - Click on this link to send us message
No comments:
Post a Comment